Cisco PIX serial numbers from a remote location

Certifications

RSS

Last web search to here

whois msftncsi.com
google xsx mouse cursors
antennae search .com
xsx alpha blended cursors
no add legacy on device manager
xsx alpha blended cursors
xsx alpha blended cursors
xsx alpha blended cursors
xsx alpha blended cursors

Wednesday, October 5. 2005

Cisco PIX serial numbers from a remote location

On the Cisco 501, the Sh Ver command shows a serial number that is 2 charâ€™s too short. Add â€œ88" to the front of it to get the real serial number.

So in the Show Ver, if the serial number shows as â€œ123456789", then the real serial number would be "88123456789".

Posted by Aaron Tiensivu in VOIP at 18:23 | Comments (3) | Trackbacks (0)

14163 hits

Trackbacks

Trackback specific URI for this entry

No Trackbacks

Comments

Display comments as (Linear | Threaded)

I find this highly debatable. Cisco is not stupid. In addition to that it didn't work out for me as per your blog. Perhaps this is valid for some cases.

#1 Mario A. Spinthiras (Homepage) on 2007-12-31 03:29 (Reply)

It worked for me with a PIX 515E (verified with the paper label in the bottom).

Besides, in the cisco site the picture that explains how to find the serial number of the pix is just plain wrong.

#2 Michele Bergonzoni on 2008-01-11 12:50 (Reply)

Oh well. Then again we could always ditch the pix since they aren't much of a device anyways

Waste of bloody money!

#2.1 Mario A. Spinthiras (Homepage) on 2008-01-11 18:54 (Reply)

Add Comment

Name
Email
Homepage
In reply to
Comment	E-Mail addresses will not be displayed and will only be used for E-Mail notifications. Standard emoticons like :-) and ;-) are converted to images.
	Remember Information? Subscribe to this entry